ECG ST 13730 Mode D'emploi page 7

Bun toasting attachment; toasting grill:
Place the toasting rack 9 on the toaster as shown and place in it the baked goods (croissant, bun ...) you want
to cook on it. Set the low browning intensity in the range (1–3) and press switch 4 down until it locks in the
bottom position. The baked goods will start toasting automatically.
Wait for toasting to stop automatically, or press the Cancel button 6 to end the toasting process. Be careful
not to touch the heated parts of the rack when removing the baked goods from the attachment 9.
What you need to know about slices of bread?
Type of bread, its moistness, content, age, thickness and number of heels. All of this affects the browning
setting. If you intend to toast two slices of bread next to each other, they should be of the same type, same
degree of moistness and of the same age (bread shall be kept in an enclosed package). Always keep sliced
bread, intended for toasting purposes, in a dry area.
The overall thickness of bread slices should not exceed 2.5 cm.
Any type of bread, small loafs and baked goods without toppings can be used in the toaster, including frozen
baked goods. In general, darker types of bread should be toasted at a higher browning setting than lighter
types. To obtain an especially light loaf of bread, spray it lightly with water prior to toasting.
Very thin slices will not be centred automatically and should be toasted at a lower browning setting to
prevent one side of the bread from becoming burnt.
CLEANING
Unplug the appliance and let it cool down before cleaning. Slide the crumb tray out of the appliance and
empty it. Clean the crumb tray regularly, use a scratch brush to remove burnt crumbs. Clean the outer surface
of the toaster with a damp cloth. Do not use sharp objects or abrasive cleaning agents to clean the toaster.
Do not immerse the toaster into water or use a dish washer to clean the appliance.
TECHNICAL INFORMATION
Nominal voltage: 220–240 V~ 50/60 Hz
Nominal input power: 1350 W
WARRANTY: The following situations void the warranty:
Incorrect or inappropriate handling of the device, failure to observe safety measures applicable to the device,
the use of force, alterations or repairs made by a party other than authorized service center.
Components subject to normal wear and tear are not covered under warranty.
USE AND DISPOSAL OF WASTE
Wrapping paper and corrugated paperboard – deliver to scrapyard. Packing foil, PE bags, plastic elements – throw into
plastic recycling containers.
DISPOSAL OF PRODUCTS AT THE END OF LIFETIME
Disposal of electric and electronic equipment (valid in EU member countries and other European
countries with an implemented recycling system)
The represented symbol on the product or package means the product shall not be treated as domestic waste.
Hand over the product to the specified location for recycling electric and electronic equipment. Prevent
negative impacts on human health and the environment by properly recycling your product.
Recycling contributes to preserving natural resources. For more information on the recycling of this product,
refer to your local authority, domestic waste processing organization or store, where you purchased the
08/05
product.
This product complies with EU directive requirements on electromagnetic compatibility and
electrical safety.
The instruction manual is available at website www.ecg-electro.eu.
Changes in text and technical parameters reserved.
7