Technical Specifications; Installation On To The Boiler - Ferroli SUN G 30/2 PRO Notice D'installation Et D'entretien

TECHNICAL SPECIFICATIONS

SUN G
Output
Flow
Functioning
Fuel
Max Viscosity at 20°C
Electrical power supply
1 stage / 2 stage pump calibration
Motor
Max. absorbed power
Condenser
Trasformator (voltage / secondary current)
Electric protection rating
Noise level *
45° nozzle with vacuum / half-empty cone
Weight
* Sound pressure measured in the manufacturer's combustion laboratory, with burner operating on a test boiler
and at maximum output.

INSTALLATION ON TO THE BOILER

Remove the burner terminal 6. Insert the flange 2 in the burner nozzle with the insulating ga-
sket 4 and fitting the insulating cord 5. Insert the burner in the boiler so that the nozzle enters
the combustion chamber according to the boiler manufacturer's instructions. Tighten the 2
screws 1 to secure the burner. Fix the flange 2 to the boiler with the 4 screws 3. From inside
the boiler, refit the terminal 6 and the post-ventilation terminal 7 with the screws supplied.
min
max
min
max
1,5 °E - 6 CSt - 41 sec; R1
6 1 4
3 2 5
30/2 PRO
147
379
12,3
31,9
Two stages
Light oil
230/50 o 60 single-phase
10/18
370
715
18
7,5x2 / 48
20
75
5,00
28
7
kW
kW
kg/h
kg/h
V/Hz
bar
W
W
μF
kV/mA
IP
dB(A)
GPH
kg
UK
25