YORKVILLE nx 25 P Manuel De L'utilisateur page 4

the Level control on each
cabinet sets the volume
for that cabinet. When
used with a microphone
connected to one NX25P
at the beginning of the
chain the Level control
will normally be set to
maximum unless it is
desired that a particular
cabinet be set quieter
than the rest. When a
line source is used the
Level control will set the
volume for the enclosure.
If there are multiple NX25P
enclosures in a system, it
will be necessary to set
the Levels separately. If
using a mixer for the line
source, the mixer should
control the level of all the
NX25P enclosures. (When
a mixer drives the NX25P
enclosures, the Level control should be set
to maximum). If there are multiple NX25P
enclosures it may be desirable to set the level
control of individual enclosures to less than
maximum (if it's desirable for that enclosure to
be quieter).
Treble, Mid and Bass Controls
These controls affect all the sound coming out
of a particular NX25P enclosure. These controls
do not affect the sound at the Mix Out. In a
200 WATT POWERED LOUDSPEAKER ENCLOSURE
3
1
MIC IN
3
1
LINE IN
3
2
MIX OUT
2
MIC GAIN
MIC IN
TREBLE
LINE IN
MIX OUT
SHIELD
SIGNAL / LIMIT
POWER
25
2
MIC GAIN
2
Shield
LEVEL
1
system with multiple cabinets
it will be necessary to adjust
the bass, Treble, Mid and
Bass controls on all individual
enclosures.
Signal / Limit LED
min max
This dual LED illuminates
green when signal is present
dB
6 6 and red when limiting.
MID
Shield Switch
dB
6 6
BASS
The Shield switch disconnects
the ground connection on
dB
6 6
the Line In. This may help
LEVEL
prevent hum or buzz under
some circumstances.
dB
00 0
ON Power LED and
Switch
OFF
The Power Switch turns the
POWER
power on and off for the
NX25P enclosure, the green
LED will illuminate when
the power is on also indicating a properly
functioning fuse.
Voltage Selector Switch
Select the proper voltage for the
geographical region in which the NX25P
P
will be used. The unit is set for 115V when
used with the standard North American line
voltage. For European operation set the unit
to 230V. If in doubt of the line voltage please
contact your local Yorkville dealer.
5kHz
20 WATTS
TONE CONTROLS
30hz/5kHz
180 WATTS