Narcom 4 Remote Handset - NAIM NAT05 XS Mode D'emploi

NA R CO M R e m ote H a nd s et
6 NARC OM 4 Re mote H ands et
The NARCOM 4 remote handset is is a multi-functional remote control handset designed
to be used with Naim CD players, integrated amplifiers, preamplifiers, preset tuners and
subwoofers.
To fit batteries, remove the battery cover and insert the batteries into the body taking care
with their orientation. Replace the battery cover.
6. 1 U s ing NARC O M 4 w it h t h e N A T 05 XS
Operation of the NARCOM 4 handset is based around
three types of keys: System Component
and Soft Keys.
6.1.1 System Component Keys
System Component Keys
Soft Keys
the into modes appropriate to each system
component: CD player, tuner (tun) preamplifier, etc.
Global Keys operate specific component functions
regardless of the System Component Key
available at all times.
6.1.2 Gobal Keys
Global Keys
operate as follows:
5 6
vol ( & ): Adjusts the preamplifier volume and the
volume control position.
mute: Reduces the preamplifier volume to zero. A
second press restores the volume.
bal ( 3 & 4 ): Adust channel balance on appropriately
equipped products.
CD Transport: Control CD transport and track selection.
scan: Switches the tuner to scan mode and starts
a scan from the current frequency upwards.
When a station is found the scan will stop.
Pressing the
mode: Switches the tuner between frequency,
scan and preset
6.1.3 Soft Keys
In tuner mode the Soft Keys
presets. Soft keys operate as follows:
prog
The key enables specific FM station frequencies to be
assigned to preset memories. To assign a station to a preset
either tune manually by inputting the station frequency
directly from the numeric
( 3 ), right ( 4 ) or scan keys. Stations found by the tuner
scanning the FM band can also be saved as presets.
When a station is tuned press and hold the
tuner is now in preset program mode: the preset indicator
will flash and the display will show
Enter the desired preset number from the numeric keypad
or by using the left ( 3 ) and
hand side the display will show
Keys, Global Keys
keys switch the operation of
setting and are
scan key will resume the scan.
modes.
are used to store station
keypad or by using the left
prog
key. The
--
on the left hand side.
right ( 4 ) keys. On its right
— P
or if the preset number
is already in use. If the preset number is already in use a
different preset number can be entered at this point. Exit
from program mode and save the new or overwritten
preset by pressing and holding the
preset program mode without saving (or overwriting) a
0 0
preset, select on the numeric keypad.
To erase a preset number, select the preset and press and
hold the disp key.
The disp key can also be used to switch the tuner display
on and off. When the display is switched off it will illuminate
temporarily when a front panel button or handset key is
pressed.
6 . 2 N A RC O M 4 K e ys
Disp key (soft)
Numeric keys (soft)
System Component keys
CD Transport (global)
Volume and mute keys (global)
Left (
Prog key and Mon key (soft)
Balance keys (global)
Scan and Mode keys (global)
Note:
unused.
prog key. To exit from
3 ) and right ( 4 ) keys (soft)
The info and select keys are
E5