Publicité
Les langues disponibles
Les langues disponibles
•
Never pull the mains cable to disconnect the
mains plug from the socket, always seize the
plug .
•
For cleaning the power supply unit only use
a dry, soft cloth; never use water or chemi-
cals . For cleaning the camera, the cloth may
be slightly wet and a mild detergent may be
used .
•
No guarantee claims for the units and no li-
ability for any resulting personal damage or
material damage will be accepted if the units
are used for other purposes than originally
intended, if they are not correctly connect-
ed or operated, or if they are not repaired in
an expert way . Likewise, no liability will be
accepted for any data loss due to operating
errors or a defect or for any consequential
damage caused by this data loss .
If the units are to be put out of oper-
ation definitively, take them to a local
recycling plant for a disposal which is
not harmful to the environment .
3 Installation
1) A test operation is recommended in order
to find the best mounting location . For this
purpose, operate the camera temporar-
☞
ily (
next chapters) . To avoid scratches,
leave the protective film on the dome during
installation (gloves are provided) .
CAUTION When it gets dark, the infrared
LEDs (2) will switch on . When setting up the
camera, never look directly into the lit infra-
red LEDs at close range . The infrared light
may cause eye irritation . However, the infra-
red radiation is far below the emission limit
and rated risk-free according to EN 62471 .
2) Release the two screws and open the cover
(1) of the compartment on the rear of the
camera housing . Remove the transport lock
☞
(
arrow in fig . 3) of the camera . Close the
cover . Also remove the adhesive tape used
for fixing the movable part of the camera .
➂
3) At the mounting location, drill four holes
for fixing the mounting plate (6) of the wall
bracket and, if necessary, drill a hole for the
connection cable (alternatively, guide the
cable through one of the knock-out holes
on the side or underneath the camera base) .
A drilling jig is provided . Use the dowels pro-
vided, if required .
4) Guide the cable of the camera through the
tube of the wall bracket . Use the three hexa-
gon socket screws (4) to fasten the bracket to
the upper side of the camera . Use the locking
screw (5) to keep the camera in this position .
5) Use the four long recessed head screws to
attach the wall bracket to the mounting lo-
cation .
13
Publicité
