Publicité
Les langues disponibles
Les langues disponibles
L 8006 / SL8006
MAXI STAND MAGNIFIER EASY READING
Warning: Please read this instruction manual carefully before using the instrument
and keep it for future use.
A. SAFETY INSTRUCTIONS
-
Never place the magnifying glass in the sun, this could trigger a fire by reverberation.
-
Never look to the sun or to a lamp through the magnifying glass.
-
The device is intended exclusively for private and not for commercial use. Only use this device
as describe in this instruction manual.
-
Keep it away from heat sources such as radiators, to avoid deformation of plastic parts.
The device is intended exclusively for private and not for commercial use. Only
-
use this device as describe in this instruction manual.
Before to use, make sure that the supply voltage corresponds with the voltage
-
marked on the rating label.
Do not place any part of this appliance in water or any other liquid.
-
Do not handle the unit or plug with wet hands.
-
When disconnecting the cable, always pull at the plug; do not pull on the cable
-
itself.
-
When using the device, always pull the power cord completely from its housing
to prevent overheating.
-
If the cord is damaged, it must be replaced by the manufacturer or its service
agent or a similarly qualified person in order to avoid an electric shock.
Never try to repair it by yourself. It must be repaired by the manufacturer or its
-
service agent or a similarly qualified person in order to avoid an electric shock.
The power cable must be checked regularly to avoid damage. If the power cable
-
is damaged it must be replaced by a qualified service center to avoid any danger.
-
Do not let the power cord on the edge of a table or work surface, and prevent it
comes into contact with hot surfaces.
-
Keep it away from heat sources such as radiators, to avoid deformation of
plastic parts.
-
Do not use coarse or abrasive sponges/cloths or steel wool to clean the
appliance.
This unit is not designed to be operated by means of an external timer or a
-
separate remote control system.
B. HOW TO USE IT
NOTE 1: When you assemble the product, please remove the protection block
EN
1. Layout all parts on a smooth surface as shown in illustration
2. Attach pole (A) to base (B) by twisting them together while rotating clockwise until
tight.
3. Position gooseneck (C) and magnifier panel (D) so that the entire piece is vertical as
in FIG2. Then, screw the pole (E) into the gooseneck (C) and tighten.
4. Insert any loose cord (G) into the pole (E).
5. Screw the second pole (E) into pole (A) and tighten.
6. Adjust the lamp to desired angle/height using the flexible gooseneck (C).
7. Insert the male plug of adapter (H) into female jack on the base (I).
8. Plug adapter into outlet and use the on/off button (J) to enjoy.
C. CARE AND MAINTENANCE
Clean the product only with a dry or slightly damp, lint-free cloth.
Do not use abrasive cleaners to clean the unit.
D. FEATURES
Materials: ABS + PMMA + Metal
100-240V - adaptator included
The European directive 2012/19/EC about electronic and electric waste, requires that
you can't throw away defective domestic appliance with common waste. Used device has to
be collect separately to optimize the recuperation rate and the recycling of the materials to
reduce the impact on the health and the environment.
This appliance is not intended for use by persons (including children) with reduced physical,
sensory or mental capacities, or by persons lacking in experience or knowledge, unless they
are supervised or instructed on the use of this apparatus by a person responsible for their
safety.Children should be supervised to ensure they do not play with this appliance.
Importé par / Importiert von / Geïmporteerd door / Imported by :
CAPTELEC, 59170 Croix - FRANCE
Publicité
