Gefu TRICA Notice D'utilisation page 3

General Points
This high-quality mincer was made of tin-plated cast iron. The surface is tin-plated.
The cutting blade and perforated disk, perforation 4.5 mm, are made of solid stainless steel, which gives
them a special degree of sharpness and an extremely long service life.
Instruction
Before using for the first time, please clean all parts thoroughly under running lukewarm water.
If a greyish discoloration appears on the processed matter when it is used for the first time, rinse off the
individual parts again or add some washing-up liquid to the water if they are very dirty.
After use, clean with warm water and then dry thoroughly. If the mincer has not been used for a long
time, it is recommendable to rub some vegetable fat into the tin-plated elements and the steel elements
in order to prevent corrosion.
The mincer is not dishwasher-safe.
Assembly
The plastic bushing (2) is pushed onto the worm (3).
The worm (3) is pushed into the machine casing (1). The front square peg on the worm serves to hold the
cutting blade (4), whereby the cutting surfaces point towards the perforated disk (4), which is pushed
onto the peg. When pushing on the perforated disk, make sure the casing's securing pin is positioned in
the recess on the perforated disk. The union nut (6) is screwed on now. The crank (8) is pushed onto the
back end of the worm (3) and connected to the crank bolt (7). The plastic bases (9) is pushed onto the foot
of the encasing (1). The mincer is ready for use once it is attached to the worktable by means of the wing
screw (10). The wing screw is adjustable and is suitable for table plate thicknesses of 25-70 mm.
Accessory
The following perforated disks made of
stainless steel are available for the following mincers:
Size 5
Art. no.
Ø 4 mm 88027
Ø 6 mm 88028
Ø 8 mm 88029
Ø 10 mm 88030
Ø 15 mm 88031
Spare blade 88025
The cookie nozzle are also available from GEFU of course:
Size 5 art. no. 14220
Size 7/8 art. no. 14230
Insert the shortbread biscuit attachment between the perforated disc (5) and the union nut (6).
The cutting blade (4) remains in a mounted position.
We wish you success with this high-quality mincer.
6 5 4 3
Size 7/8
Art. no.
88039
88040
-
-
88043
88037
2 1 7
9 8
10
3