Publicité
Les langues disponibles
Les langues disponibles
SCANNERS
1
2
3
4
5
6
7
8
9
12) SWITCH DMX WIRELESS
This switch is used to enable or disable the wireless DMX function
13) DISPLAY DMX WIRELESS CHANNEL
This display shows you the selected wireless DMX channel number
14) DMX WIRELESS ANTENNA
Maximally extend the antenna for a greater scope of wireless DMX
15) DMX OUTPUTS
16) BATTERY COVER
This console can run on sector (area of a power adaptor AC/DC 9V supplied), or 9V battery. If the sector is not available,
insert a 9V battery into the battery compartment (note the polarity) and move the switch to the battery position
17) POWER CONNECTOR
Connect the external transformer supplied with the 9V DC console on this socket
18) SWITCH
This switch has three position. The Central off position the console. The other two positions to turn on the console (either
on transformer or battery).
OPERATING
ACTIVATION WIRELESS DMX TRANSMITTER
-Press the WIFI selector to activate the transmitter (the led lights). The DMX channel display lights.
-Use the small ID button (located to the right of the display wireless DMX channel) to select the transmission channel of the
DMX wireless (from 0 to 9 then A to F so all 16 channels)
-The TXD led is lit which means that the console transmits the DMX signal
Use these receptors DMX wireless compatible such as the W100DMX, the W500DMX or the stand alone PARLED-W3 and
PARLED-W12 leds projectors.
When only the console and a compatible receiver to work together, the TXD led will blink quickly
To disable the wireless transmitter, press once again on the WIFI button (the led goes off)
CANAUX DMX
1-6
7-12
13-18
19-24
25-30
31-36
37-42
43-48
49-54
Publicité
