AEG DVB5860B Notice D'utilisation page 29

appliance returns to its previous speed
settings.
When the function is turned
on, additional touch on the
button
effects.
3.3 Activating and
deactivating the filter
notification
Filter alarm reminds to change or clean
the charcoal filter and clean the grease
filter. The filter indicator
(red) for 30 seconds if the grease filter
must be cleaned. The filter indicator
flashes (red) for 30 seconds if the
charcoal filter must be replaced or
cleaned.
4. CARE AND CLEANING
4.1 Cleaning the grease filter
Each filter must be cleaned at least once
a month. Filters are mounted with the
use of clips and pins on the opposite
side.
To clean the filter:
1. Pull the cover to open it.
2. Press the handle of the mounting clip
on the filter panel underneath the
hood (1).
does not have any
is turned on
1
Refer to filter alarm in care
and cleaning chapter.
1. Switch on the control panel.
2. Make sure that the icons are turned
off.
3. To activate or deactivate the charcoal
filter notification touch
seconds.
If the charcoal filter
notification is activated, the
filter icon
five times.
If the charcoal filter
notification is deactivated,
the filter icon
three times.
1
2
3. Slightly tilt the front of the filter
downwards (2), then pull.
Repeat the first two steps for all filters.
4. Clean the filters using a sponge with
non abrasive detergents or in a
dishwasher.
The dishwasher must be set
to a low temperature and a
short cycle. The grease filter
may discolour, it has no
influence on the
performance of the
appliance.
5. To mount the filters back follow the
first two steps in reverse order.
Repeat the steps for all filters if
applicable.
for 3
flashes (red)
flashes (red)