Description; Get To Know Your Compressor - Emax HULK POWER HP01P002SS Mode D'emploi

Description

7
6
5
4
fig1
3

Get to know your compressor

Please refer to fi g 2.
1. TAnK DRAIn VALVE
(located on bottom of tank) - The tank drain
valve can be opened to allow moisture and
compressed air to be released from the air tank.
The tank drain valve should
WA RNI NG
always be opened slowly to
avoid damage to equipment and possible injury.
2. TAnK -
two gallon (7.6 liters) tank
3. RUBBER fOOT
Reduces compressor vibration and movment.
4. SAfETY VALVE -
The safety valve automatically relieves pressure
from the air tank in the event of excessive
pressure build up. Safety Valve is preset at
factory. Do not attempt to make any adjustments
to the safety valve. Periodically pull the ring on
the safety valve end to check that it is working
properly.
8 9
2 1
5. RESERVOIR AIR PRESSURE GAUGE -
6. PRESSURE SWITCH -
N O T IC E
OFF position before performing any maintenance
or plugging the compressor into a power supply.
7. AIR fILTER -
3
3
Indicates pressure of compressed air built up in
the tank.
Controlled by the red tipped power switch lever
which turns the air compressor on and off . When
switch lever is pulled up, compressor is turned
off . When lever is moved down to the "Auto"
position, the pressure switch is engaged and will
start the compressor pump automatically when
tank pressure is below the factory-set minimum.
The pressure switch continues to monitor the
pressure and turns the pump off when the
pressure reaches the factory-set maximum.
Always make sure that the
compressor power switch is in the
Ensures the air being pressurized is free of
contaminants and reduces the amount of noise
the pump generates.
10
11
HP01P002SS man v.171212