Publicité
ITEM: TL27324
Accessories
1. Main frame X 1PC
2. Frame with wheels X 2PCS
1
3. Paddle adaptors X 2PCS
4. Screw X 2PCS
8x45.5mm
5. Washer X 2PCS
6. Locknut X 2PCS
7. Screw with plastic topper X 2PCS
8x26.7mm
Assembly instructions
Step 1: Insert both pieces of frame with wheels in to main frame.
Step 2: Ensure that the frames are pushed together as much as possible,
push the screw through aligning the holes and add the washer on each side
Then use tools to tighten with the locknuts.
Step 3: Insert adaptors on the top of the frame with wheels, then tighten the screw with plastic.
Operation / Guide to using
1. Roll the stand and make sure your motorcycle rear wheel is in the middle of the frame.
2. Loosen the screws with plastic topper while holding the adaptors
3. Adjust the position of the paddle adaptors to match the width of your motorcycle dual swing
arm and then tighten the screw with plastic.
4. Raise the stand with circled handle and move the stand to the position under the swing arm,
then press down the stand in order to raise your motorcycle. Make sure the paddle adaptors
are snug up against the swing arm.
Important
Always keep this stand away from children.
Check the stand is in good condition before using it.
It's better to ask your friend or family to hold your motorcycle when using this stand.
3
2
7
5,6
4
45,5
26,7
Publicité
