Publicité
Les langues disponibles
Les langues disponibles
Before installation select a suitable location for the fan where it is unlikely to
•
cause an obstruction.
Draw a vertical centre line approx. 80 mm long on the wall
•
Draw 2 horizontal lines 20 mm apart to mark the upper and lower screw
•
holes for the bracket.
On the upper line mark 2 holes 11 mm either side of the centre line.
•
Drill holes on the marked points using a 6 mm (¼") masonry bit, and insert a
•
wall-plug.
Fix the bracket to the wall and fully tighten all screws.
•
Slide the fan onto the bracket then insert and tighten the thumb screw in the
•
hole at the top of the switch plate(9) to hold in position.
Plug the mains lead into a 13 Amp mains socket. If any other appliances are
•
connected to the same extension lead, make sure that it is rated for the total
power of all appliances connected.
If connecting via an extension lead, make sure that the lead is rated at 3
•
Amps or more, and that it is fully unwound.
Switch the appliance on at the mains socket.
•
Use the On/Speed button to start the fan, initially the fan will operate at low
•
speed. Press the On/Speed button to choose between Low/Medium and
High Speed
The swing button allows the unit to oscillate the fan head to cover a greater
•
area.
To switch Off push the OFF button.
•
2818
INSTALLATION
OPERATION
3
Ver. 3 - 04/14
Publicité
