ZIBRO CLIMA PX150 Comfort Manuel D'utilisation page 51

Connecting
Pass the connection tube through the hole (at least dia. 50 mm) if present.
1
Remove the protection caps (if used previously).
2
Reconnect the refrigerant tubes (tighten the nuts quickly to make a good
3
seal), the drain tube and the electrical cable.
Close the connection box on the indoor unit.
4
H
CLEANING
First of all switch off the unit and pull the plug.
Clean the housing with a soft, damp cloth. Never use aggressive chemicals, petrol,
detergents or other cleansing solutions. Clean the screenfilter regularly with a
vacuum cleaner. See also chapter D "Air filter".
NOTE!
Never use the air conditioner without screenfilter.
I
STORAGE
Drain the condensed water completely. To remove remaining water, tip the
1
unit over and remove the rubber stop.
2 Clean (or replace) the filter.
Put the unit on a sunny day in fan mode for a couple of hours to ensure that
3
the inside becomes completely dry.
Store cable as shown, protect the unit against dust and store in a dry place
4
not accessible for children.
4
51