Samsung DVE45T3200 Série Manuel D'utilisation page 30

Installation
Check code
0 Vent condition is good.
Clg (Cg) The vent is clogged.
About 80 % of the vent is clogged.
C80 (C8)
(This may decrease the drying
performance.)
Over 90 % of the vent is clogged.
C90 (C9)
(This may lead to poor drying
performance or cause malfunction)
The internal temperature of the
dryer is too low (below 32 °F (0 °C))
Ct or too high (over 104 °F (40 °C)) and
therefore vent blockage cannot be
detected.
tC Temperature sensor error
Unit is detecting items inside the
C1 drum or there is an error on the dry
sensor.
Unit is detecting door is open
dC
9C1 Abnormal voltage detected
30 English
DV3200T_DC68-03784N-00_EN.indd 30
Meaning Solution
1. Clean the lint filter.
2. Check your vent condition.
(Refer to the "Ducting
requirements" section)
* You must take measures (such as
cleaning) through expert personnel.
Leave the dryer at room
temperature (41~95 °F (5~35 °C))
for an hour and check again.
Contact a service center.
Remove items from the drum and
check again.
If the problem continues, contact a
service center.
Close the door properly and check
again.
If the problem continues, contact a
service center.
Check the power connection. (Refer
to the "Connect the electrical wiring"
section)
If the problem continues, contact a
service center.
2020-05-25 11:10:20