Assembly; Installing Debris Shield; Installing Trimmer Head - Maruyama M42BK-QC-ST Manuel Du Propriétaire/De L'utilisateur

Assembly

Installing the Debris Shield
WARNING
POTENTIAL HAZARD
• Foreign objects can be thrown by the
String Trimmer.
WHAT CAN HAPPEN
• Contact with thrown objects can cause
personal injury.
HOW TO AVOID THE HAZARD
• Never operate the String Trimmer
without the debris shield in place.
CAUTION
POTENTIAL HAZARD
• The String cutoff blade is sharp.
WHAT CAN HAPPEN
• Contact with cutoff blade could cause
serious cuts or personal injury.
HOW TO AVOID THE HAZARD
• Keep hands, feet and clothing away
from cutoff blade.
1. Fasten the string cutoff blade to the debris shield
with two M5 x 12 screws and hex nuts.
M5 x 30
Screw (2)
Gearcase
Plate
Hex Nut
String Cutoff Blade
2. Attach the debris shield to the gearcase with the
two M5 x 30 screws and plate as shown.
Shaft
Debris Shield
M5 x 12
Screw (2)
— US-8 —

Installing Trimmer Head

IMPORTANT: The boss adapter must be, installed
on the attaching shaft between the gearcase and the
trimmer head as shown. And Trimmer head adapter
is left-head.
1. Install the boss adapter onto the attaching shaft out
of the gearcase.
2. Align the hole in the boss adapter with the hole in
the gearcase.
Gearcase
3 mm Hex Wrench
Trimmer Head
3. Insert the 3 mm hex wrench into the holes in the
boss adapter and gearcase to lock the attaching
shaft.
4. Thread the trimmer head adapter into the attaching
shaft, then tighten the trimmer head firmly by
hand.
5. Remove the 3 mm hex wrench from the boss
adapter and gearcase.
CAUTION
POTENTIAL HAZARD
• If the trimmer head is not adequately
tightened, it can come loose from the
String Trimmer during use.
WHAT CAN HAPPEN
• This may cause damage to property or
personal injury.
HOW TO AVOID THE HAZARD
• Make sure the trimmer head is securely
fastened to the attaching shaft in the
gearcase.
Attaching Shaft
Boss Adapter
Trimmer Head Adapter
(Fully visible)