Publicité
Les langues disponibles
Les langues disponibles
EN
Menu 3: Configuration of CPL
This menu allows associating the unit to the remote CPL programmer connected to the same
power grid.
"+"
In menu 3 press the
Switch the CPL programmer, remote control desk to the "association" mode (see
corresponding manual). Press shortly the
"CPL"
screen and then
"
"
OK
Press
key to proceed with the following setting.
Menu 4: Backlight time settings
Adjustable backlight is available from 0 to 225 seconds in 15 seconds steps (90 seconds by
default).
"+"
To modify press
or
next setting.
Menu 5: Selection of temperature display in AUTO operation mode.
1 = Permanent display of the premises temperature.
0 = Permanent display of the set point temperature.
"+"
To modify press
or
configuration mode.
for 5 seconds. CPL message will start blinking.
"+"
"EnrE"
key.
message confirming the association.
"–"
"
OK
, keys, then press the
"–"
"
OK
, keys, then press the
message displays on the
"
to store and proceed with the
"
to store and exit the
10
1
2
3
4
5
6
7
OK
>5 sec.
1
2
3
4
5
6
7
OK
1
2
3
4
5
6
7
OK
Publicité
