Empty Water Reservoir; Warnings; Maintenance - Qlima H 130 Manuel D'utilisation

D.

EMPTY WATER RESERVOIR

The control button will flash for 10 seconds if the water reservoir is empty. Simultaneously
the moisturiser will emit a beep. The moisturiser will automatically turn off. Full the water
reservoir as described in the installation chapter and switch the moisturiser on again.
G
TAkE CARE
When removing the water reservoir drops of water at the bottom of the reservoir
could cause water damage. Dry the bottom of the water reservoir before moving
it.
G
TAkE CARE
When removing the water reservoir from the moisturiser all settings will be lost.

4. warninGs

1 Never fill the water reservoir with water hotter than 30°C.
2 Never fill the reservoir through the mist nozzle.
3 Ensure that the filler cap of the reservoir is not leaking. Close the filler cap tightly.
4 Ensure that the device and the reservoir are always clean. Remove any dirt before
using the device.
5 Do not position the outlet of the cold mist nozzle too close to equipment, furniture
etc. to avoid water damage.
6 Check the actual air humidity regularly in the room to prevent any damage to
furniture, equipment etc. from a too high humidity.

5. maintenance

Unplug the adapter from the wall socket before carrying out any maintenance, so that the
device is dead.
1 Clean the ultrasonic evaporation element and the water reservoir with a soft cloth.
Then rinse the water reservoir well with tap water and dry the ultrasonic evaporation
element with a soft cloth.
2 Clean the ultrasonic element every time you fill the water reservoir (indicated by
arrow). Carefully remove any calcium and other deposits with the supplied brush.
4
38