Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Slide the tubular motor into the winding shaft (Figure
STOP
1.
First slide the driver (8) into the winding shaft (5).
IMPORTANT
For winding shaft with interior seams, the motor (9) must have
sufficient clearance.
For Small / Medium only
Preparatory work when using precision tubes (Figures
5.a
RolloTube Small
5.b
RolloTube Medium
5.c
Never strike the motor (9) violently
to insert it in the winding shaft (5).
This will destroy it.
1
2
1
2
5
2.
Next, press the winding shaft (5) completely onto the adapter (10).
IMPORTANT
Take care that the adapter (10) does not slide off of the limit ring (18)
on the drive head (12) during assembly, or a malfunction will occur;
see Page 54.
5.a
Measure the distance between the adapter and the rear third of the
1.
driver and mark this distance on the precision tube.
2.
Saw a notch
1
at the end of the precision tube so that the raised
part
2
of the adapter can be pushed fully into the tube.
NOTE
There must be no play between the notch
2
part
.
The dimensions of the notch
motor, see figures.
)
-
)
5.f
1
and the raised
1
depend on the type of tubular
GB
47
Publicité
Table des Matières
