Connection With The Dimmerpacks; Operation - Futurelight WIZARD Wing Mode D'emploi

Connect the connection cable of the power-unit with the DC IN-socket. Plug the power unit into your outlet.

5.2 Connection with the dimmerpacks

DMX-512:
The wires must not come into contact with each other, otherwise
Only use a stereo shielded cable and 3-pin XLR-plugs and connectors in order to connect the controller with
the fixture or one fixture with another.
Building a serial DMX-chain:
Connect the DMX-output of the WIZARD Wing with the DMX-input of the nearest dimmerpack. Always
connect one output with the input of the next fixture until all fixtures are connected.
Caution: At the last fixture, the DMX-cable has to be terminated with a terminator. Solder a 120
between Signal (–) and Signal (+) into a 3-pin XLR-plug and plug it in the DMX-output of the last fixture.

6. OPERATION

After you connected the device to the mains, the WIZARD Wing is ready for use. Switch the device on via
the Power-switch.
With the masterfader, you can adjust the total light output of all channels (0-100%).
You can dim the individual channels via the channel-faders Channel 1-16.
7. PROBLEM CHART
PROBLEM
No power.
No signal output.
8. CLEANING AND MAINTENANCE
We recommend a frequent cleaning of the device. Please use a soft lint-free and moistened cloth. Never use
alcohol or solvents!
There are no servicable parts inside the device. Maintenance and service operations are only to be carried
out by authorized dealers.
Should you need any spare parts, please use genuine parts.
Should you have further questions, please contact your dealer.
the fixtures will not work at all, or will not work properly.
CAUSE
The power unit is not connected.
Standby-mode activated.
DANGER TO LIFE!
Disconnect from mains before starting maintenance operation!
Check the connection cable of the
power unit and any extension-cables.
Switch off blackout by pressing the
Blackout-button.
12/23
Ω
resistor
REMEDY
51885200.DOC