English
● Since the built-in microcomputer takes about 3 seconds to confi rm that the back
pack power supply being charged with UC36YRSL is taken out, wait for a minimum
of 3 seconds before reinserting it to continue charging.
If the adapter of back pack power supply is reinserted within 3 seconds, the back
pack power supply may not be properly charged.
ATTACHING AND DETACHING THE CARRIER
Attaching the Carrier (Fig.10)
1.
Put on the carrier.
2. Adjust the length of the belt so that the waist buckle is
fi xed in place on your waist.
3. Pull the side straps downward to adjust the height.
4.
Adjust the check buckle so that the side straps lie in a
comfortable position.
Detaching the Carrier (Fig.11)
1.
Press the buttons on both sides of the buckle chest
simultaneously to release it.
2. Press the buttons on both sides of the waist buckle
simultaneously to release it.
3. Take off the carrier.
USED AS A POWER SUPPLY FOR CORDLESS POWER TOOLS (DC 36V)
WARNING:
● Read the instruction manuals for power tools that are to be connected beforehand.
● Always check to confi rm that cordless power tools are switched off before
connecting them to the Back Pack Power Supply adapter.
1.
Check to confi rm that the main switch is off . (Fig. 12)
The main switch is off if the green power indicator is not
illuminated when the power switch on the switch panel is
pressed.
2. Put on the Back Pack Power Supply.
Tighten the chest buckle and waist buckle so that there
is no looseness but still easy to move. Then adjust the
length of the band and strap.
3. Check to confi rm that the cordless power tool to be
connected is switched off .
•
Plugging the adapter into the power tool adapter with the
switch set at on may result in unexpected operations,
leading to injury.
•
Check that the switch to the power tool returns to the off
position when pulled once.
14
Buckle
chest
Fig. 10
Buckle chest
Waist buckle
Fig. 11
Switch
panel
Cordless
power tool
Back pack
power supply
Adapter
Fig. 12
Side
strap
Waist
buckle