How To Use The "Reference To Zero; How To Use The "Alarm" Function; How To Display Alarm Limits - Sammic L-EQ Manuel De L'utilisateur

When this happens :
A) Let go the plate if you are holding it.
B) If the message continue, turn off the scale and turn it on again.

HOW TO USE THE "REFERENCE TO ZERO"

It is possible for the scale to show a number in the display without having any product on the plate
due to voltage variations, rough handling, or some other factor. When this happens, simply press
the key and the view finder will return to "zero". The word "zero" will appear in the display. This
operation is commonly known as "resetting to zero".
HOW TO USE THE
When you do not have enough light you can use the backlight to improve the readability of the data
on display. To turn on and turn off the backlight just press the
HOW TO USE ALARM FUNCTION
Press the key, it'll be display "hi lmt?" In the display
Then press or
Press key for increment or
decrement will be faster. For save high alarm value and go to adjust low alarm value press
be display "lo lmt?" In the display.
Then press or
[ Key for increment or
decrement will be faster]. For save low alarm value press
Note: for disable alarm, make the same procedure but set high and low alarm to zero (0.000)

HOW TO DISPLAY ALARM LIMITS

Press or key for display high or low alarm limit. For exit press
12 ENGLISH
KEY
keys for set high alarm limit.
key for decrement value, if key still pressed the increment /
keys for set low alarm limit.
key for decrement value, if key still pressed the increment /
key.
. The scale it'll be ready to weight.
.
. I'll