Termozeta MATICA 1260 CERAMIC Mode D'emploi page 15

USE INSTRUCTIONS
CHOICE OF THE IRON TEMPERATURE
Turn the iron temperature control knob (18) so that the proper temperature corresponds
to the indicator (17) according to the type of cloth to be ironed.
Fig.: 1
FOR STEAM IRONING
HOW TO FILL THE BOILER WITH WATER
• Always unplug the iron from the outlet when filling the boiler with water.
• Unscrew cap (5) counterclockwise and slowly pour the water through the boiler opening
by using the provided funnel to avoid any leakage. Screw up the cap again clockwise.
• Only use running water to fill the boiler without exceeding its maximum capacity:
never add detergents, chemical additives or water softeners.
SUGGESTION: If water in your area is particularly calcareous, it is advisable to
use distilled water.
WARNING!
Never unscrew the boiler cap (5) while the appliance is working but wait for the
appliance to completely cool down before opening it.
STARTING UP
• Rest the appliance on a firm flat surface.
• Place the iron on the boiler base (3).
• Fill up the boiler as described in the previous paragraph.
• Completely unwind the power cord (7) and plug into the outlet.
• Put switch (2) to position "1" in order to switch on the appliance.
• Turn the iron temperature control knob (18) to the steam ironing position.
• The pilot light (19) on the iron will go on immediately and will go out a few minutes later,
when the required temperature is reached.
• When the pilot light (8
will be on until the appliance is turned off.
• During operation, the iron light (19) and the "steam ready" pilot light (8
then automatically go out indicating that the iron temperature and the pressure in the
boiler are constantly under control.
• Rest the iron on the boiler base (3) during ironing pauses.
High temperature steam ironing (cotton, linen)
Medium temperature steam ironing (wool, silk)
Low temperature ironing (synthetic, fibres)
) goes on, it is possible to use the jet of steam. The pilot light
) go on and