Green Clean Digi Back Mode D'emploi page 3

Instructions for use
The system offers a two part cleaning process to remove
all types of dust, dirt and contamination.
PART ONE Anti Static Adapter
Contact free removal of dust and loose particles with anti-static
effect.
Attention: screw the valve with the Anti Static Adapter on the Green Clean
Hi- Tech Air+Vacuum Power can. Hold can in upright position! Do not shake
during or before use. Actuate trigger with direction away from the sensor
first, to clean the nozzle from potentially remainig liquid gas. This is important,
because the liquid gas could cause damage
of the surface physically through a freezing-
shock or dissolving effect on the very sen-
sitive layer of the sensor-glass. (so called:
upsite down versions of the cans DO NOT
prevent small amount of remaining gas in
the nozzle) the gas itself is inert.
Hold the sensor in vertical positi-
on as picture .
1
Actuate trigger with direction away from the sensor first, then
position the Anti Static Adapter about 5 cm or 2 inch away
from the low-pass filter, and actuate in short blasts of about
0,5 seconds the trigger.
The Anti Static Adapter is made from Thunderon which has the
ability to neutralize static charges, therefore you are blowing
away the loose particles while at the same time removing
the static charge of the sensor surface. The special
1
quality of the brush is life-long and only if becomes very dirty does it lose its
anti-static abilities.
PART TWO Digi Back Cleaner & Silky Wipe
If after part one the sensor surface is not completely clean and
some "weldet on" particles or smudges are present, part two
is implemented.
Apply one drop of the Green Clean Digi Back Cleaner with the special bottle-
dispenser direct on the low-pass-center (picture
"Silky Wipe" cloth to spread the liquid over the sensor surface and wipe off. Do
2 3
portant that the cleaning liquid does not dissolve instantly, as
do alcohol based products, but it evaporates slowly to give enough time for
the „Silky Wipe" to spread the liquid and dissolve all dirt before evapora-
tion and absorption into the cloth.
„Silky Wipe" is made from a particularly flat, tightly spun silk derivative
and contains no chemical binding materials or bleach. The cloth is
extremely soft, yet has the slow absorption qualities necessary
to make this particular cleaning process so effective.
GB
) and use the Green Clean
2
not use too much pressu-
re (picture ).
3
The special Green Clean
cleaning liquid does not
contain alcohol or
aggressive cleaning
substances, but is able
to dissolve fatty/oily
substances and other
residual dirt. It is im-