Insignia NS-BTHDP Guide De L'utilisateur page 14

07-324 NS-BTHDP reduced.fm Page 12 Friday, August 3, 2007 1:29 PM
5
After pairing and connection have succeeded, a short, high
tone plays, and the blue indicator light flashes. The headset
is now ready for use.
The Insignia Bluetooth Stereo headset will automatically
reconnect to the last-connected phone / device. If the connection
is failed due to phone / device not found, the headset will
automatically enter into pairing mode.
Pairing with MP3 players and other devices
You will need to pair your headset with Bluetooth-enabled
devices, such as MP3 players, for it to work. Your headset
headset can be paired with up to eight compatible phones or
devices. However, it can only be connected to one phone at a
time.
Pairing the headset with Bluetooth-enabled devices
To pair the headset with other Bluetooth devices:
1
Make sure that the headset is off. Press and hold the
Multifunction button for more than seven seconds, until
short, low tones come from the earpiece and the blue and
red lights flash alternately.
2
Refer to the user guide of the device to set it into pairing
mode.
3
When the device finds the headset, "NS-BTHDST" or
"NS-BTHDP" appear. Accept and confirm the message by
entering the keycode 0000 (four zeros).
4
After pairing and connection are finished, a short, high-tone
beep plays, and a blue light flashes. The headset is now
ready for use.
Connecting with two devices simultaneously
It is possible to connect the Insignia Bluetooth Stereo headset to
two devices at the same time, so that you can listen to music and
keep phone connectivity at the same time.
www.insignia-products.com
12
NS-BTHDP/NS-BTHDST