Publicité
Les langues disponibles
Les langues disponibles
Installation instructions
①
④
⑦
1 Check all delivered items to ensure they are complete (see "Included in delivery" on the left page)
and are in a good working condition.
2 Unpack all parts. Then put the aluminum posts together and fix an insulator on top of each post.
3 Place the 4 aluminum posts to build a square 10 x 10 m.
Use provided bungee cords and tent pegs to tighten them lightly.
4 Drive the pegs in carefully – they are made out of aluminum!
5 From a loop with the tape and hang it into the first insulator.
Unroll the whole tape and insert the end of the tape in the gate handle and fasten it with a knot.
6 Pull the tape through all insulators.
7 Make sure the tape is tightened and all posts are fixed. Move the pegs if necessary.
8 Hang up the P30 energizer with the fence clip into the tape, preferably at the post to make sure
the tape is still tight.
9 Finally, clam the earth clip at the peg and switch on your energizer. Your paddock is now ready to use.
②
⑤
⑧
③
⑥
⑨
7
Publicité
