Maintenance And Storage; What If There Are Problems - Beurer MC2000 Mode D'emploi

7.

Maintenance and storage

Warning!
• The device must be switched off using the hand
switch after every use and before cleaning.
• Pull the mains plug out of the socket.
• Retract the mains cable.
> Wipe the Shiatsu office chair from time to time with
a dry, lint-free or slightly damp cloth.
> Every two to three months, wipe the office chair
using a clean cloth with a small amount of care
product for artificial leather.
> Afterwards, dry the office chair with a clean, dry
cloth.
8.

What if there are problems?

Problem
Massage heads are
moving slowly.
Massage heads are
moving in the upper or
lower area only.
Grinding noises during
operation.
The massage cannot be
started.
The massage function
stops when the chair is in
operation.
Cause
The load on the massage heads is too
great.
The massage was only activated for the
limited area in question.
These sounds are normal and are caused
by the operation of the motor or from the
massage heads that are rubbing against
the cushion.
The mains plug is not connected to the
socket.
The Shiatsu massage was not switched on
at the hand switch.
The maximum operation period was
reached.
Artificial leather is sensitive to grease. Clean the
Shiatsu office chair only using care products suitable
for artificial leather.
Important!
• Clean the device using only the methods specified.
• Under no circumstances may liquid enter the
device.
• Do not use any solvent-based cleaning products.
• Do not use any harsh cleaning products.
These can damage the surface.
Solution
> Reduce the contact pressure from
your body.
> Press the FULL BACK, UPPER
BACK or LOWER BACK button to
change or extend the area.
No action is necessary.
> Plug the mains plug into the socket.
> Start the Shiatsu massage using
the on/off button
> Switch off the Shiatsu office chair
and allow to cool down for 30
minutes before switching on again.
18
.