Actiontec electronic T2200H Mode D'emploi page 3

Configure the Gateway
1. Open a Web Browser (FireFox or Internet Explorer, for example). In the address bar, enter
http://192.168.1.254 then press Enter on the keyboard.
Note: When you open your web browser you may get a page cannot be displayed error. This is normal and
will not effect the instructions in step 1.
2. The GUI login username and password values can be found on the bottom sticker.
3. The "Main Menu" screen appears.
Note: If this screen does not appear, make sure our Ethernet port is configured for Dynamic IP.
Configure Wireless Connection and Security
1. Click on Wireless Setup
2. Select a name for your wireless network and enter it in the "Network Name" field. Then click Apply.
3. Click on Wireless Security from the left column menu.
4. Select the type of wireless security that you want to use Actiontec recommends using WPA&WPA2. The
following steps will show you how to enable WPA&WPA2 wireless security.
Note: All of your other wireless devices will need to support that same type of wireless security chosen in
order to connect to your wireless network.
5. Enter in a password or pre‐shared key. The key must be at least 8 characters long. Click Apply to
continue.
Congratulations you are now connected!
3