Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
English
11. Install the "C" brackets back into the mounting position. Insert sheet metal screws
through the top holes and tighten, insert the 5/16" bolts through the bottom holes
to hold on t the brackets to the vehicle. Add washers and nuts, do not tighten down
yet. (see Fig. E-2, E-4).
12. Attach the step to the brackets. Insert the sheet metal screws through the upper
holes on the "C" brackets, and tighten, install 5/16" bolts, washers and nuts through
the lower holes to secure the step to the brackets. Now tighten all the screws, bolts
and nuts firmly (see Fig. E-2 & E-4).
13. To complete the installation, install the plastic door entry cover, making sure the
screws will not pierce any wires when putting harness back in place.
"C" Bracket
Figure E-1
Sheet Metal Screw
1 1/8" Bolt
Figure E-2
4
"C" Bracket
Step Casting
www.bullytruckaccessories.com
8
Metal Body
1 1/8" Bolt
2
Metal Body
3
1
Figure E-3
"C" Bracket
Figure E-4
4
"C" Bracket
Step Casting
Figure E-5
Door Entry
Rocker Panel
Wire Harness Underneath
Floor Carpet
www.bullytruckaccessories.com
English
A/C Lines
Hose Strap
2
A/C Hose
Metal Body
3
1
Plastic Cover
9
Publicité
Table des Matières
