Macally MBTBUDS Mode D'emploi page 3

How to charge the headphones
1. Open the cover on the headphones to expose the
micro USB charging port.
2. Connect the Micro USB end of the USB charging
cable to the micro USB charging port.
3. Connect the USB-A end of the USB charging
cable to a USB charger (not included).
4. While charging the battery status LED will stay
solid red.
5. When fully charged the battery status LED will
turn white.
6. Unplug the USB charging cable and close the
micro USB charging port cover to protect against
dust/water.
Notes
* The headphones will automatically turn off while
charging.
** When the headphones have not been used for a
longer period of time, the battery level may
decrease and it will take longer time to charge. In
order to avoid this, we recommend to fully charge
the headphones every 6 months
How to pair the headphones?
1. Open Bluetooth
smartphone, tablet or computer. Make sure
Bluetooth is On.
2. Separate the earbuds to turn on the
headphones.
3. Press and hold the Bluetooth sync button for
three to five seconds until it flashes red/white.
4. "MACALLY MBTBUDS" will show up in the list of
Bluetooth devices (this may take up to a minute).
5. Click on "MACALLY MBTBUDS". Once
"MACALLY MBTBUDS" shows "Connected" you're
ready to go!
Note
Once paired, the headphones will automatically
turn on/connect each time the ear buds are
separated.
How to use the headphones
Swap ear buds and in-ear supports
The headphones include 3 sets of different size ear
buds and in-ear supports (S, M, L). To swap them
out, simply pull off the existing set and attach a
different size set as needed. When re-attaching the
in-ear support, make sure it sits up on the opposite
side of the cable as shown in the images below.
2
preferences on your