Operating Instructions; Warning; Safety Precautions; On/Off Switch - Haussmann DP1000 Manuel De L'utilisateur

WARNING

For your own safety, read the entire operator's manual
and safety instructions before using the machine.

SAFETY PRECAUTIONS

• Be aware of general power tool safety. Make sure all
the safety rules are understood.
• Disconnect the machine from power source whenever
adjusting or replacing any parts.
• Do not plug in unless switch is in "OFF" position.
• Keep hands away from all moving parts.
• Wear eye protection or face shield during operation.
• Make sure all mobile parts move freely and are free
from interference.
• Never turn the machine "ON" with the workpiece
contacting the drill bit.
• Properly support long or wide workpieces.
• Turn switch off and disconnect power whenever drill
press is not in use.
• Keep drill press maintained. Follow maintenance
instruction.
• Ensure the drill bit is secured in the chuck before
operating the machine.
• Remove the chuck key before starting the machine.
• Tighten all lock handles before starting the machine.
• Hold the workpiece firmly against the table.

ON/OFF SWITCH

Refer to Figure 10.
The ON/OFF switch is located on the top of the motor. To
turn the machine ON, pull the switch to the up position. To
turn the machine OFF, push the switch to the down posi-
tion.
NOTE: When the machine is not in use, the machine
should be locked in the "OFF" position to prevent unau-
thorized use.
• To lock the machine, turn the switch to "OFF" position.
Pull the key out. The switch cannot be turned on without
the key.
• If the key is removed when the switch is at the "On:
position, the switch can be turned off but cannot be
turned on again.
• To unlock, place the key into the slot on switch unit it
clicks into place.
Figure 10 - On-Off Switch

OPERATING INSTRUCTIONS

ADJUST TABLE HEIGHT AND TILT TABLE
Refer to Figure 11 and 12
• To raise or lower the table, loosen the table locking
handle. Move the table bracket assembly up and down
to desired height and then tighten the locking handle.
• To rotate the table around the column, loosen locking
handle, rotate table to the desired position, and tighten
the locking handle.
• To tilt the table right or left by loosening the table hex
bolt underneath the table platform.
• Tilt the table to the desired position. Tighten the table
hex bolt.
• The table alignment pin is used only when the table plat
form is level. Replace the alignment pin when the
table is returned to a level position.
• Tilt scale on the table bracket shows the degree of table
tilt.
Figure 11
Crank
Handle
Figure 12
Table
Alignment Pin
Locking
Bolt
21
Locking
Handle
Bevel
Scale
Crank
Handle