König Electronic KN-MICW620 Mode D'emploi page 3

Description LCD display receiver:
• RF: Shows the strength of the received microphone signal
• AF: Shows the microphone's audio signal level
• CH01: Selected pre-programmed channel
• A ANT: The antenna which receives the signal of the microphone (A for receiver
A and B for receiver B)
• 864.40: Frequency of the selected pre-programmed channel
• OPEN: Shows which receiver (display) is selected for the use of function
buttons 2~5
• AUTO: Shows that the microphone is powered off. Appears also when there is no
connection with the microphone on the showed frequency in the display.
• MUTE: There is no audio output from the receiver to mixer or amplifier because
the microphone is powered off or there is no reception
• TUNE: Push the SELECT button (2) to switch between manual tuning or
pre-programmed channels. With manual tuning it's possible to select the
frequency by steps of 0,05MHz. The range is 840.00MHz till 868.00MHz.
This feature offers the use of other wireless microphones operating in
the frequency band from 840.00MHz till 868.00MHz. Note: the supplied
microphones are pre-programmed from 863.00MHz till 865.00MHz
It's the responsibility of the user to ensure that the use of frequencies comply
with the local regulations and does not cause interference with other users.
IMPORTANT NOTICE:
3