Toolland FT100-TL Mode D'emploi page 3

FT100-TL
-
In case of failures which cannot be repaired
following these instructions, take your torch back to
your retailer.
Gas Leaks
-
If your appliance leaks gas (gas smell) take it
outdoors immediately to a well ventilated area,
away from inflammable sources where the seal can
be checked.
Checking The Cartridge Charge
-
Make sure the torch valve is closed, rotate the
adjusting know clockwise.
-
Shake to check if the noise of the liquid gas can still
be heard.
Injector Cleaning
-
Clean the injector by blowing through the hole.
-
Re-fit the injector and screw it down well. Check the
seal.
-
Remove the burner.
Cautions
-
Do not use needles or pins to clean the injector,
damage could result making the torch dangerous.
-
If the blockage cannot be removed, substitute the
injector.
Technical Specifications
gas category
Use this device with original accessories only. Velleman
nv cannot be held responsible in the event of damage or
injury resulting from (incorrect) use of this device.
Disposal
To all residents of the European Union - Important
environmental information about this product
This symbol on the device or the package indicates
that disposal of the device after its lifecycle could
harm the environment. Do not dispose of the unit
(or batteries) as unsorted municipal waste; it should
be taken to a specialized company for recycling. This
device should be returned to your distributor or to a
local recycling service. Respect the local environmental rules.
If in doubt, contact your local waste disposal authorities.
For more info concerning this product and the latest version of
this manual, please visit our website www.toolland.eu.
The information in this manual is subject to change without
prior notice.
v 2 - 2/12/2014
I3 butane - direct pressure
© Copyright Notice
The copyright to this manual is owned by Velleman nv. All
worldwide rights reserved. No part of this manual may be
copied, reproduced, translated or reduced to any electronic
medium or otherwise without the prior written consent of the
copyright holder.
User Guide
p. 3 / 13