Télécharger Imprimer la page

Bestron DSA220 Mode D'emploi page 15

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 11
Instruction manual
Congratulations on your new trimmer, which will give you optimum styling ability. The trimmer has a
ceramic cutter that is harder than steel. It will therefore never need sharpening. The trimmer has a trimmer
head plus attachable comb which can be set for cutting different lengths. There is also an extra shaver
head for beards and moustaches. As well as this there is a small trimmer which can be slid out and used to
make a better finish. You can use the trimmer both wet and dry.
SAFETY INSTRUCTIONS - General
Please read these instructions carefully and retain them for reference.
Use this appliance solely in accordance with these instructions.
This appliance is not intended for use by persons (including children) with reduced physical, sensory or
mental capabilities, or lack of experience and knowledge, unless they have been given supervision or
instruction concerning use of the appliance by a person responsible for their safety.
Children should be supervised to ensure that they do not play with the appliance.
Have any repairs carried out solely by a qualified electrician. Never try to repair the appliance yourself.
SAFETY INSTRUCTIONS - Electricity and heat
Before plugging in the adapter, make sure the mains voltage matches the voltage specified on the
adapter.
Make sure the socket into which you plug the adapter is earthed.
Always remove the plug from the socket when you have finished charging the device and when you
are no longer using the adapter.
When you remove the plug from the socket, pull by holding the plug, not the flex.
Check regularly to make sure the flex is still intact. Do not use the adapter if either the flex or the
adapter are damaged. A damaged flex must be replaced by a qualified electrician.
Never leave the device charging for more than 3 days.
Do not use the device while it is charging.
Do not use the device near heat sources such as radiators, or in full sunlight.
Make sure the re-charging stand and/or the adapter do not come into contact with water.
Let the battery run down completely every 2 months by using the device until it runs down. Then switch
it off and re-charge fully.
SAFETY INSTRUCTIONS - During use
Place the re-charging stand on a flat, stable surface where it cannot fall into a washbasin.
Use the device only with the adapter provided. Do not use the trimmer or the recharging stand in
combination with other types of adapters.
Make sure the trimmer or the shaving head is properly attached before switching on the device.
Take care during use. Always hold the device near the base, never near the head. Do not attempt to
remove the trimmer head or the shaver head while the device is switched on. Do not press the trimmer
or shaver head too hard against your skin. This could damage both your skin and the shaver head.
After use, remove any hairs from the device and clean it using a clean, dry cloth.
Never immerse the re-charging stand and/or adapter in water or other liquid.
Never touch the re-charging stand and/or the adapter if they have fallen in water. Remove the plug
from the socket. Do not use the re-charging stand and/or the adapter again.
TECHNICAL DETAILS
Type:
DSA220
Input:
230-240 V ~50 Hz
Output:
5.3 V 140 mA 0.742 VA
THE ENVIRONMENT
Dispose of packaging material, such as plastic and boxes, in the appropriate waste containers.
When this product reaches the end of its useful life do not dispose of it by putting it in a dustbin;
hand it in at a collection point for the reuse of electrical and electronic equipment. Please refer to
the symbols on the product, the user's instructions or the packaging.
The materials can be re-used as indicated. Your help in the re-use, recycling or other means of
making use of old electrical equipment will make an important contribution to the protection of the
environment.
Contact your municipality for the address of the appropriate collection point in your neighbourhood.
15

Publicité

loading