Danby DBC026A1BSSD Manuel Du Propriétaire page 6

OPERATING INSTRUCTIONS
DOOR REVERSAL INSTRUCTIONS
If the appliance is placed on its back or side for any length of time during this process, it must be allowed
to remain upright for 6 hours before plugging it in to avoid damage to the internal components.
Ensure the appliance is unplugged before completing the door reversal.
• Remove the screws from the lower hinge assembly and door support bracket.
• Pull the door downward to remove it from the cabinet.
• Remove the screw from the upper hinge cap and then remove the two screws from the upper hinge
assembly.
• Remove the two plastic caps from the cabinet and the door plug from the top of the door.
• Install the upper hinge assembly and hinge cap on the opposite side of the unit.
• Place the door against the unit and push up until the pin in the upper hinge assembly slots into the hole
where the door plug was removed.
• Install the lower hinge assembly and door bracket support on the opposite side of the unit.
• It is recommended at this juncture to stand the unit upright and check that the door is level and that the
gasket is making a good seal with the cabinet all the way around. If the door is not level or if the gasket
is not touching the cabinet at any point, double check that all hinge screws are tight.
• Install the two plastic caps in the holes in the cabinet where the upper hinge assembly was removed.
• Install the door plug in the top of the door where the upper hinge pin used to be.
5