Télécharger Imprimer la page

Stalgast 9705500 Notice D'instruction page 14

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 18
You must make sure if the power cable does not touch hot surfaces of the device and if it is not expo-
sed to cutting.
It is forbidden to pour water onto ceramic glass, especially when it is hot. This may lead to the glass
cracking and water penetrating to the electrical components. Also avoid the situation where the con-
tents of pots spill onto the device (e.g. due to uncontrolled boiling of contents)
During work, the device heats up - you must be careful with the possibility of burn as a result of contact
with its surface. After turning off the device, its temperature slowly decreases. Before transport or any
maintenance procedures, you must make sure that the temperature of the device decreased to a safe
level.
During work with the device, hands of operating person have to be dry (to avoid liquid drops falling
from hands to hot heating panels) and you must use protection gloves to stripping warm pots and
covers.
You cannot clean the devices using tap water.
Any repairs of the device can be made only by qualified technical staff (technical service).
3.
TECHNICAL DATA OF THE DEVICE
Accessory of the device's front (page 2):
1 - Control panel, 2 - Orange lamp (indicates active process of heating), 3 - Heating plate, 4 - Control knob,
5 - On/Off switch for external heating area
Type
Model
The amount of heating panels
Total power
Power supply
External dimensions
Power cord
4.
INSTALLATION
After unpacking, there is a need to check if the device has any visible damages. If the device has been
broken during transport, it cannot be plugged!
Before the first start, you must eliminate plastic coverage from the device. You must clean extensial
surfaces using a cloth soaked with warm water with the addition of degreaser, and then you must dry it.
Do not use any resources which could cause surface scratching.
You must set the cooker on tabletop or a stable and level foundation (it is recommended to use the fo-
undations produced in Stalgast Radom Sp. z o.o.). When required you can additionally level the cooker
with the help of adjusted legs placed under the device casing. (Fig. 4)
Conditions for connection to mains:
You must check if voltage in grid is equal to the grid indicated on device's rating plate (Fig. 6 Pos. 3)
To plug the device in electricity network you must perform plugging of the power cord in the terminal
box placed on the back wall of the device. (Fig. 6 Pos. 2). The power cord with a plug IS NOT the
part of the set and you must buy it.
You must necessarily join the device to the installation of equalising electrical potentials with the help of
Technical parameters of the device
400x700x250 mm
Figure 4. Device levelling
- 14 -
Ceramic adjustable stove
9705500
2
5000 W
400 V, 50Hz
800x700x250 mm
2
5x2,5 mm
9706500
4
10000 W

Publicité

loading

Ce manuel est également adapté pour:

9706500