Publicité
Les langues disponibles
Les langues disponibles
WARNING
Some dust created by power sanding, sawing,
•
grinding, drilling and other construction
activities contains chemicals known to the
State of California to cause cancer, birth
defects or other reproductive harm. Some
examples of these chemicals are:
Lead from lead-based paints.
–
Crystalline silica from bricks, cement, and
–
other masonry products.
Arsenic and chromium from chemically-treated
–
lumber.
Your risk from these exposures varies,
•
depending upon how often you do this type
of work. To reduce your exposure to these
chemicals:
Work in a well-ventilated area.
–
Work with approved safety equipment, such
–
as dust masks that are specially designed to
filter out microscopic particles.
Avoid prolonged contact with dust from power
–
sanding, sawing, grinding, drilling, and other
construction activities. Wear protective clothing
and wash exposed areas with soap and water.
Allowing dust to get into your mouth or eyes or
to lie on the skin may promote absorption of
harmful chemicals.
FCC CAUTION
The manufacturer is not responsible for
radio interference caused by unauthorized
modifications to this equipment. Such
modifications could void the user's authority to
operate the equipment. This device complies
with Part 15 of the FCC Rules. Operation is
subject to the following two conditions:
ADDITIONAL SAFETY WARNINGS
1. This device may not cause harmful
interference, and
2. This device must accept any interference
received, including interference that may
cause undesired operation.
NOTICE: This equipment has been tested
and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of
the FCC rules. These limits are designed to
provide reasonable protection against harmful
interference in a residential installation.
This equipment generates uses and can
radiate radio frequency energy and, if not
installed and used in accordance with the
instructions, may cause harmful interference
to radio communications. However, there is
no guarantee that interference will not occur
in a particular installation. If this equipment
does cause harmful interference to radio or
television reception, which can be determined
by turning the equipment off and on, the user is
encouraged to try to correct the interference by
one or more of the following measures:
Reorient or relocate the receiving antenna.
•
Increase the separation between the
•
equipment and receiver.
Connect the equipment into an outlet on a
•
circuit different from that to which the receiver
is connected.
Consult the dealer or an experienced radio/TV
•
technician for help.
RF warning statement:
The device has been evaluated to meet
general RF exposure requirement. The
device can be used in portable exposure
condition without restriction.
-6-
Publicité
