Hilti TE 30 Mode D'emploi page 22

Observe the information printed in the operating instructions concerning operation, care and maintenance.
Modification of the power tool or tampering with its parts is not permissible.
2.2 Chuck
TE‑C (SDS plus) chuck
TE‑T (SDS top) chuck
2.3 TPS TE 30‑M‑AVR theft protection system (optional)
The power tool may be equipped with the optional theft protection system. If the power tool is equipped with this
feature, it can be unlocked and made ready for operation only through use of the corresponding TPS key.
2.4 TE 30 / TE 30‑AVR switch
Speed control switch for smooth starting.
Forward / reverse switch
Function selector switch:
Drilling without hammering
Hammer drilling
2.5 TE 30‑C‑AVR switch
Speed control switch for smooth starting.
Forward / reverse switch
Function selector switch:
Drilling without hammering
Hammer drilling
Chisel adjustment (12 positions)
Chiseling
2.6 TE 30‑M‑AVR switch
Speed control switch for smooth starting.
Forward / reverse switch
Function selector switch:
Drilling without hammering 2
Drilling without hammering 1
Hammer drilling
Chisel adjustment (12 positions)
Chiseling
2.7 Grips
Pivotable side handle with depth gauge
Vibration-absorbing grip
2.8 Protective feature
Mechanical slip clutch
2.9 Lubrication
Oil lubrication
2.10 Active vibration reduction (TE 30‑AVR, TE 30‑C‑AVR, TE 30‑M‑AVR)
The power tool is equipped with an AVR active vibration reduction system which reduces vibration significantly
compared to power tools without AVR.
2.11 Items supplied as standard
1 Power tool
1 TE‑C or TE‑T chuck
1 Side handle with depth gauge
en
17