PLYMOVENT PHV Manuel Opérateur page 10

3 TECHNICAL SPECIFICATIONS
3.1 General
Net weight
Extraction volume (clean filter
with 2,5 m hose and EN-20):
• speed setting 'low'
• speed setting 'high'
Filter surface main filter
Filter surface HEPA filter
Filter efficiency
PHV-I only:
The warning signal starts when the extraction capacity
3
is less than 150 m /h in speed setting 'high'.
3.2 Dimensions
See fig. 1 on page 44; dimensions in mm.
3.3 Electric system
See the identification plate and the separate electrical
diagram.
Power consumption:
• speed setting 'low': ±70%
• speed setting 'high': 100%
3.4 Ambient conditions
Min. operating temperature
Max. operating temperature
Max. relative humidity
IP class
3.5 Sound pressure
The level of the A-weighed sound pressure is 70 dB(A)
according to ISO 3746. Measurements performed in
the workshop with a PHV fitted with a welding torch.
4 GENERAL DESCRIPTION
The machine consists of the following main
components (see fig. 2 on page 44):
A control panel
B fans
C mains cord
D air intake Ø 48 mm
E bottom
F pre-separator
G wheels
H integrated prefilter
0507345000/PHV/011213/G
16 kg
3
140 m /h
3
230 m /h
2
12 m
2
0,4 m
99,9% (incl. HEPA
filter H12)
5°C
40°C
80%
50
I main filter Dura-H
J outlet cover
K HEPA filter
L top cover
4.1 General description
The machine has been specially designed for extracting
and/or filtering fumes and gases that are released
during the most common light and medium welding
processes.
With its wheels, the handle and its compact design the
machine is extremely suited to be used in relatively
small workshops or near sources of pollution without a
fixed location.
4.2 Operation
The machine works in accordance with the
recirculation principle.
The extracted fumes pass the air intake and enter the
pre-separator in which primary filtration takes place
and where sparks, if any, are separated. Subsequently
the air passes the prefilter and the main filter, in which
most of the fume particles are filtered out. Finally, the
fan blows the air into the HEPA filter where the
remaining fumes are separated. The cleaned air is
returned into the workshop via the outlet grid. With the
optional hose connection HCH-45 the air can be
discharged elsewhere, for example into the
atmosphere.
The welding fumes can be extracted at source in the
following ways:
A by the supplied extraction hose Ø 45 mm
connected to the welding torch
B by the supplied extraction hose Ø 45 mm
connected to the extraction nozzle
5 INSTALLATION
5.1 Unpacking
Check that the machine is complete. The package
should contain:
• portable welding fume extractor
• extraction hose 2,5 m/Ø 45 mm
• 4 carbon brushes
• user manual
• electrical diagram
5.2 Installation
The machine is ready for use.
1. See chapter 6.2 Use
1
;
1
.
EN - 9