Marvel MA15C Série Instructions D'installation, D'utilisation Et D'entretien page 24

OVERLAY DOOR PANEL INSTALLATION - MA15C MODELS
CAUTION
!
Step 1: Verify door alignment
Verify that the door is aligned correctly with the cabinet
prior to fabricating the custom panel. Failure to do so
may result in mis-alignment of the custom panel with the
hinge bracket. The door should be parallel to the sides
and top of the ice machine. If alignment is necessary
the door may be adjusted by loosening the 2 screws
which secure the top and/or bottom hinge adapter
brackets, located on the top and bottom of the door
and adjusting the door side to side. Use a
wrench, for this procedure. (See Figure 40 below). When
Hinge adapter bracket
located on the top and
bottom of the door.
Figure 40
Step 2: Remove door
Remove the top hinge pin from the hinge with an 1/8" allen
wrench. Remove the door by angling the top of the door
outward and lifting the door off the bottom hinge.
(See detail in Figure 40).
Step 3: Remove gasket
Lay the door on its front being careful not to scratch it. To
gain access to the screw mounting holes remove the door
gasket by peeling up and out of the channel.
" allen
5
32
Remove top
hinge pin to
remove the
door.
"
9
32
(7mm)
Door should be
parallel to top
and sides of
ice machine.
NOTE
For the door to work properly it is necessary to maintain
a minimum space of
9
32
adjusting the top and bottom hinge adapters.
24
" (7mm) between the door and