Changing The Door Opening Direction; Tools Required - Aspes 5FAC495INNF Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 30
CHANGING THE DOOR-OPENING DIRECTION:

TOOLS REQUIRED:

µ An Allen screwdriver and a screwdriver with a TORX tip.
PROCEDURE:
1. Unplug the refrigerator and take everything from
the compartment.
2. Take out the skirting board and screws and remove
the bottom hinge.
3. Remove the freezer door.
4. Remove the cover of the central hinge screws, and loosen the two screws
holding it in place.
5. Remove the refrigerator door.
6. Take out the top hinge pin and fit it on the other side
of the refrigerator.
7. Change the position of the lower hinge pin.
8. If fitted, change the lateral handles to the other side.
9. Reverse this procedure to refit the doors.
Switch the appliance on and check that the sealing strips
seal properly when the door is closed.
BEFORE SWITCHING THE REFRIGERATOR ON:
µ Clean the inside with warm water and bicarbonate of soda. Rinse and dry
carefully.
µ Wait for 2 hours before starting, to ensure that the motor lubricants have
stabilised.
µ If the refrigerator has been switched off, wait 4 hours after restarting before
placing food inside.
5

Publicité

Table des Matières
loading

Table des Matières