Panasonic EY4541 Instructions D'utilisation page 10

• It is recommended to use a dust adapter
for reducing the risk of damaging the
surface of the object being cut.
Attaching or Removing Battery
Pack
1. To connect the battery pack:
Line up the alignment marks and attach
the battery pack.
• Slide the battery pack until it locks
into position.
2. To remove the battery pack:
Push on the button from the front to
release the battery pack.
IV. OPERATION
1. Push the switch lock lever down, pull
Alignment
marks
2. Once cutting is finished, release the
3. Check that the temperature of the
Cutting
Button
- 10 -
the power switch.
• The speed increases with the amount
of depression of the power switch.
power switch.
blade has dropped sufficiently, and
then remove the blade.
NOTE:
• Check that there are no obstacles to
cut underneath workpiece.
• Check that there are no objects such
as nails in the material to be cut.
If the blade comes into contact with any
such objects during cutting, a strong
reaction force will be generated and
severe injury may occur.
• Do not place your hand on the object
in the direction cutting is to take place.
If this is not observed, there is a risk
of injury.
• Do not touch the jigsaw blade im-
mediately after cutting.
If this is not observed, burns may occur.