Schwaiger WALED 1 Mode D'emploi Et Consignes De Sécurité page 13

3. Insert the new batteries in their corresponding holders.
Ensure the polarity is correct.
Whenever you change the batteries, first remove the
old batteries from their holders and then insert the new
batteries.
4. Put the cover back on again. Ensure that the three ter-
minals grip into their corresponding holes.
5. Use the screwdriver to re-fasten the two screws on the
rear.
7. Use
Press on the on/off button to switch on the LED warning
light; the light emits a 360° rotating beacon light when
turned on.
Press the on/off button again to change through the follow-
ing 9 light modes in sequence.
USER MANUAL
13 13