JENCONS Powerpette Notice D'emploi page 3

Introduction
The Jencons
POWERPETTE
been carefully designed and manufactured as lightweight, cordless pipetting aids for use with all
plastic or glass pipettes from 1– 100ml.
These new
POWERPETTES
rechargeable, long life, environmentally friendly, 1.2V nickel metal hydride batteries.
POWERPETTES
These triggers also control intake and dispense speeds.
A battery warning light (4) is triggered whenever the charge in the batteries is low and they
should then be recharged. Pipetting with
are connected to their chargers (5).
POWERPETTES
between three modes of operation:
Slide switch position 'High' (top)
Slide switch position 'Low' (middle)
Slide switch position 'G' (bottom)
Technical Data
Batteries
Battery service Life
Charger
Overall weight
Filter (8)
Manifold material
Case material
Nosecone material
Pipette holder
Pipette types
,
POWERPETTE
are constructed in recyclable materials and operate on two
have uniquely formed finger triggers to minimize any high pressure points.
have a conveniently located slide switch (3) which allows the user to select
Suction and dispense at full speed (Blow-out)
Suction and dispense at reduced speed (Blow-out)
Suction at reduced speed, dispense by gravity (To Deliver)
2 x 1.2V nickel metal hydride
500 – 1000 cycles from empty
75m A /h for 14 hours plug-in; UK, European, USA, Indian,
Japanese or Australian versions
Installation (over voltage) category II
Double insulation indicated on charger by symbol
180 g without stand
Hydrophobic 25 mm dia 0.45 µm (fitted) plus two
additional spare filters
1x 0.45 µm
1x 0.20 µm
ABS
ASA
Polypropylene (10)
Silicone (9)
Plastic or glass 1 – 100 ml
and
POWERPETTE
Plus
POWERPETTES
1
OPERATOR
can also take place while the units
Instructions
have