SC Tessera Set Manuel D'utilisateur page 70

SC ELLO TS CLEAROMIZER – COMMISSIONING OF THE DEVICE
Switching the Atomizer Head
1� Remove the clearomizer from the battery of your e-cigarette�
2� Turn the e-cigarette so that the mouthpiece faces the floor, and remove the atomizer head base with integrated
airflow control from the glass tank�
3� Remove the old atomizer head and insert a new one� Please first drip a few drops of e-liquid directly into the
wick of the coil to make it fully saturated before first use�
4� Connect all parts again and ensure that no e-liquid can overflow and/or leak out�
5� Screw the clearomizer back to the battery�
Adjusting the Air Supply
By slightly turning the airflow control ring on the base of the atomizer head, you can increase or decrease the air
supply according to your personal preferences� The greater the air supply, the lower the drawing resistance� In
particular, please ensure there is a sufficient air supply during sub-ohm vaping�
Changing the Mouthpiece
The mouthpiece is placed on the top cap of the Clearomizer� It can be removed by gently pulling up and once
again attached by applying gentle pressure on clearomizer� The mouthpiece may be cleaned with warm water�
Make sure that it is completely dry before reinserting into the clearomizer�
68