Changes To The Controler; Getting In And Out; Driving The Scooter - ENJOY Centuro Mini Mode D'emploi

Centuro Mini
| Scooter
USB port
Your Centuro Mini has a USB port on the right side under the handlebars
(fig. 24). You can use this to conveniently charge your smartphone or
other mobile terminals when your scooter is switched on.
4.1.1. Changes to the controller
24
Changes to the programming of the controller may only be made by an
authorized supplier. Changes to the programming have an effect on the
speed, acceleration and deceleration. This can lead to life-threatening
injuries of the user and / or third persons if improperly carried out

4.2. Getting in and out

Ensure that the scooter is switched off before sitting on it.
25
• You will find it easier to take a seat if you turn the seat 90° to the
side from which you want to sit down (see chapter 3.5.2 Seat).
• Fold the armrest up on the side on which you want to get in.
• Now sit down.
• Then turn the seat to face in the direction of travel and/or fold the
armrest back down.
26
• Adjust the steering column so that you can comfortably reach all
the controls (see chapter 3.5.1).
• To get out, follow the instructions accordingly in reverse order.
However, take out the key beforehand so that you can ensure that
no unintended actions or movements occur.
56
Ensure that the seat firmly locks in position again.

4.3. Driving the scooter

You should make your first journey on a level site with ample space
• Ensure that you are sitting correctly on your scooter. Set the speed
as low as possible. You can increase the speed when you are more
familiar with handling the scooter.
• To switch on your scooter, insert the ignition key into the ignition
lock on the control panel and turn the key a quarter turn to the
right (Fig 27).
• To switch off the scooter, turn the key a quarter turn to the left.
After getting out of the scooter, always ensure that you have
removed the ignition key and do not leave the scooter unattended
with the ignition key inserted.
• Please make sure that you do not have your hand on the forwards
/backwards lever when you switch on your scooter. This would
cause your scooter to display an error message. In this case, turn it
off and then on again to rectify this error.
• Pull back the speed selection lever on the right to move forwards.
The further you pull back the lever, the higher the speed. The speed
can go up to the maximum speed that has been preset using the
speed control. Release the lever to stop gently. Practice these two
procedures in order to get used to them.
• Steering is easy and works exactly like a bicycle in that you turn the
handlebars in the direction in which you wish to move. Leave plenty
of distance when you travel around a curve so that the rear wheels
are able to follow the path of the front wheels and so that you do
not cut across objects.
Bischoff & Bischoff GmbH |24/10/2019 - revision: 1
Centuro Mini
Scooter |
27
28
57