Monacor ESUB-6W/WS Notice D'installation page 5

PA Subwoofer for Wall Installation
These instructions are intended for installers with
specific knowledge of sound reproduction using
100 V technology . Please read the instructions
carefully prior to installation and keep them for
later reference . The corresponding drawings can
be found on page 2 .
1 Applications
This subwoofer is specially designed for PA sys-
tems . It is used as a bass support in new or exist-
ing installations . The subwoofer is provided with
a transformer for operation in 100 V systems, but
it can also be directly connected to a low-imped-
ance amplifier output .
The integrated crossover network allows
direct connection of satellite speakers (imped-
ance: 4 – 8 Ω) to ESUB-6W .
2 Important Notes
The speaker corresponds to all relevant directives
of the EU and is therefore marked with
•
The speaker is suitable for indoor use only .
Protect it against dripping water, splash water
and high air humidity . The admissible ambient
temperature range is 0 – 40 °C .
•
For cleaning only use a dry, soft cloth; never
use water or chemicals .
•
No guarantee claims for the speaker and no
liability for any resulting personal damage or
material damage will be accepted if the speaker
is used for other purposes than originally in-
tended, if it is not safely or correctly installed,
or if it is overloaded .
If the speaker is to be put out of oper-
ation definitively, take it to a local recy-
cling plant for a disposal which is not
harmful to the environment .
All rights reserved by MONACOR
reproduced in any form or by any means for any commercial use.
.
INTERNATIONAL GmbH & Co. KG. No part of this instruction manual may be
®
3 Installation
WARNING During operation, there is a haz-
ard of contact with a dangerous
voltage of up to 100 V at the
speaker cable . Installation must
be made by skilled personnel only .
1) Before installing the subwoofer, switch off the
PA amplifier so that the speaker cable will not
carry any voltage!
2) Use screws to fasten the wall brackets provided
at a suitable place (fig . 2) .
3) When connecting the speakers, make sure
that all of them have the same polarity and
that the amplifier is not overloaded . To make
handling easier, the green terminal blocks can
be disconnected from their plug-in connec-
tions .
4) After connecting, hang the subwoofer onto
the wall brackets (fig . 3) .
100 V mode
5) Set the switch INPUT SELECT (1) to the position
70V/100V and set the switch MODE (2) to the
position MONO .
6) Connect the speaker cable to the terminal
block 70V/100V INPUT (3) . Select the corre-
sponding terminals to define the desired power
rating .
7) At the output SATELLITE OUTPUT (5), a satellite
speaker with an impedance of 4 – 8 Ω can be
connected to the terminals LEFT . It is not pos-
sible to connect a 100 V speaker to this output
in any operating mode .
4 Ω mode
5) Set the switch INPUT SELECT (1) to the position
DIRECT and use the switch MODE (2) to select
mono or stereo mode .
6) Connect the amplifier output to the terminal
block DIRECT INPUT (4) . For mono mode, only
use the terminals LEFT .
7) Satellite speakers with an impedance of 4 – 8 Ω
can be connected to the output SATELLITE
OUTPUT (5) . For mono mode, connect the
satellite speaker to the terminals LEFT .
Subject to technical modification .
5