Heating Water To A Specific Temperature And Keeping Warm (Keep Warm) - ADE KG 2100-1 Mode D'emploi

Use
We recommend that you do not boil stale water again. Pour it out or use it
when cooled down to water flowers.
Pay attention to the following:
‚ If you do not remove the water tank from the base, the display remains illuminated
for approx. 10 minutes, after which the device switches off automatically. The
water temperature (which will drop again) is shown on the display.
‚ You can switch off the device at any time by pressing and holding the
a few seconds.
‚ If you press the
the KEEP WARM function, see next section):
− Press
once: Kettle goes into standby mode.
− Press briefly again: Kettle is switched off.
‚ If you remove the kettle from the base during the heating process and then place
it back on the base, the heating process stops but the settings made remain saved.
Pressing resumes the heating process.
Heating water to a specific temperature and keeping
warm (KEEP WARM)
The keep warm function is not available for 100 °C.
1. Proceed as described in the section "Heating water to a specific temperature"
(steps 1-6).
2. Press and hold SET for approx. 2 seconds.
"KEEP WARM" appears on the display.
3. Select the desired temperature range by repeatedly pressing the SET button.
A beep sounds each time the button is pressed.
The symbol of the selected function flashes, e.g.
The water is then heated to the appropriate temperature. The current water
temperature is shown in the upper part of the display.
As soon as the set temperature is reached, a beep sounds and the corresponding
symbol stops flashing.
4. Pour out the water slowly. Do not open the lid while pouring.
The water is kept warm for about 2 hours after the kettle has been reset.
The device then switches off automatically.
24
button only briefly during the heating process (also applies to
at 40 °C.
Kettle with temperature setting KG 2100-x
button for