EN
Wall mounting
1. Measure ?mm and drill 2 parallel hole(1/4 in each) in the
wall.
2. Firmly apply a dowel into each hole in the wall.(dowel
only required for solid wall)
3. Install the bracket to the wall using screw
4. Attach the soundbar to the bracket , and press and push
the soundbar to the right location.
Specifications
Output Power
Frequency Response
Bluetooth Version
Power Input
HDMI(ARC) , Optical, Coaxial,
Function
EQ Mode
Size
- 7 -
25W*2+50W
50Hz-20KHz
5.0
100-240V 50/60Hz
Bluetooth, USB
Music, Movie, News, Game
FCC Statement
Changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to
operate the equipment.
This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is
no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following
measures:
--
Reorient or relocate the receiving antenna.
--
Increase the separation between the equipment and
receiver.
--
Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
--
Consult the dealer or an experienced radio/TV technician for
help
This device complies with part 15 of the FCC rules. Operation
is subject to the following two conditions (1)this device may
not cause harmful interference, and (2) this device must accept
any interference received, including interference that may
cause undesired operation.
EN
- 8 -