NASA WS100 Manuel D'utilisation page 9

3 - SETTING THE TIME
- Press and hold the (MODE) button for 3 seconds to enter the time setting mode.
- Use the (UP) and (DOWN) buttons to adjust the values. Hold the buttons down to speed up scrolling.
- Press the (MODE) button to confirm.
- If the buttons are not pressed, the unit returns to the normal display after 10 seconds.
4 - SETTING THE DATE
- Press the (MODE) button twice to select the Date function.
- Press the (MODE) button for 3 seconds to enter the setting mode.
- Use the (UP) and (DOWN) buttons to adjust the values. Hold the buttons down to speed up
scrolling.
- Press the (MODE) button to confirm.
- If the buttons are not pressed, the unit returns to the normal display after 10 seconds.
5 - SETTING THE ALARM
- Press the (MODE) button 3 times to select the Alarm function.
- Press the (MODE) button for 3 seconds to enter the setting mode.
- Use the (UP) and (DOWN) buttons to adjust the values. Hold the buttons down to speed up scrolling.
- Press the (MODE) button to confirm.
- If the buttons are not pressed, the unit returns to the normal display after 10 seconds.
ACTIVATING/DEACTIVATING THE ALARM
- Press the (UP) button to activate ( ) or deactivate the alarm (no symbol is displayed).
STOPPING THE ALARM
- The alarm will go off at the programmed time. To stop the alarm, press the (UP) button; it will
sound again the next day at the same time.
SNOOZING THE ALARM (SNOOZE)
- When the alarm sounds, press the (SNZ) button: the symbol will flash and the alarm will stop.
The alarm will sound again after 8 minutes.
- Then press the (UP) button to deactivate the snooze function.
6 - CHANGING THE TIME DISPLAY FORMAT (12 > 24)
- Enter the Alarm mode and hold the UP button until the display returns to the Time mode.
- The time display format will change.
7 - COMFORT LEVEL : ICONS
Humidity between 40% and
Humidity of 70% or Humidity of 40% or
70% and temperature between
more less
20°C (68°F) and 25°C (77°F)
8 - BACKLIGHTING
- By default, the backlight is off (to save energy).
- Press the (LIGHT) button to activate the backlight for 7 seconds.
9 - CLEANING AND MAINTENANCE
- Before cleaning the unit, disconnect the power supply (remove the batteries).
- Only clean the outside of the unit and use a dry cloth. Do not use cleaning fluids to avoid damaging
the electronics.