Maintenance Table - Komet Vacuboy Notice D'utilisation

Maintenance and Fault Repair
8.1

Maintenance table

Carry out maintenance work according to the following table.
Arrange for any faults to be repaired by a skilled technician or by your dealer:
Frequency Which position
immediately Oil moistened exhaust filter
element (strong build-up of
smoke)
Plexiglas cover
Bottom of the sealing pads
(brass contact surfaces)
before putting Cable
into operation
Machine and vacuum chamber
Silicone rubber
Teflon strip
Cover seal
Operating Instructions- Translation
What to do?
Replace the exhaust filter element
-
Replace if cover shows signs of
-
cracks, hairline cracks, deep scratches
or any other damage
If there is a deterioration in seal seam
quality
- Clean
- Replace if damaged
- Clean
- Clean
- Replace if damaged
Frequency
Which position
before putting Sealing pads and cylinder
into operation (pump rod)
weekly Bottom of the sealing pads
(brass contact surfaces)
Pump rod for the sealing
cylinder
The whole device
Oil reading display on the oil
inspection glass
after 100 Pump
operating hours
every 500 Exhaust filter element
operating hours
every 500 Pump
operating hours
nd
with every 2 oil Oil filter
change
after 6 months
Pump
19 04 249 - 01.01.2012
What to do?
- Check for easy movement
Where necessary, lubricate
-
(lubricant: sewing machine oil)
- Clean
- Bring the device up to operating
temperature for 30 minutes or
Activate the service program
-
By doing so any water found in the oil
will be removed from the device.
Check the oil reading and oil quality
-
- Where necessary top up the oil or
carry out oil change (for oil type see
chapter "Technical Data")
- Carry out first oil change
Replace exhaust filter element
-
- Replace the exhaust filter element
earlier in case of severe
contamination, increased power
consumption, increased temperature
and reduced separating effect
- Carry out oil change
- Replace oil filter
Carry out oil change
-
Eng - 24 /32